94
Setup
1. Install Pilot into Spindle Collet.
Place cutter on pilot and twist to lock.
2. With motor off, squeeze Feed Lever and
measure depth "A".
3. Adjust depth adjustment to slightly greater
than specification.
4. Remove cutter.
Operation
1. Insert Pilot thru Workpiece.
2. Install cutter on to pilot.
3. Actuate motor trigger.
4. Squeeze Feed Lever until full depth is
obtained.
5. Measure depth "A"; adjust Depth
Adjustment as required.
Ordering Information
When ordering a Quackenbush Back Spotfacer tool,
it is necessary to also order the Spindle Collet, Pilot
Spindle and Cutter. These parts are not automatically
shipped with the tool.
1. Specify Tool Model Number
2. Specify Spindle Collet Part Number
(Note: Collet diameter must equal Pilot Spindle diameter)
3. Specify Pilot Spindle Part Number
4. Specify Cutter Number.
Spindle ColletPilot Spindle
Cutter
Specialty Tools
Comments to this Manuals